Pickleball Court Installation in Greensboro

Most residential pickleball court installations run $19,000-$50,000, depending on base preparation, surface material, fencing, and line marking. A bare concrete slab with painted lines sits at the lower end; a full build with fencing, lighting, and a cushioned acrylic surface sits higher. An on-site evaluation produces an itemised written estimate so you see exactly where the money goes.

A regulation pickleball court is 20 feet wide by 44 feet long. Add a minimum 10-foot buffer on each end and 7 feet on each side for safe play, and you need roughly 40 by 64 feet of usable flat ground. Tighter yards can still work with reduced run-off zones for casual play.

It depends on whether you have roughly 40 by 64 feet of reasonably flat ground after accounting for setbacks from fences and structures. An on-site evaluation measures the available space, checks grade, and confirms whether the layout works before any commitment is made.

Generally yes, but local zoning setbacks and drainage patterns near the foundation matter. Courts built too close to a structure can direct runoff toward the building if drainage isn’t properly graded. The on-site evaluation checks both setback requirements and drainage flow before the layout is finalised.

Concrete is harder, holds its shape longer, and gives a more consistent bounce, but costs more upfront and can crack if the sub-base shifts. Asphalt is less expensive initially and handles minor ground movement better, but softens in intense heat and needs resurfacing sooner. Both work well under a quality acrylic coating applied over a properly prepared base.

DIY court kits exist, but proper base compaction, slope grading for drainage, and accurate line layout are difficult without the right equipment. A court built on a poorly prepared base will crack and puddle within a few seasons. One written scope covering site prep, surfacing, and line marking from the start avoids expensive repairs later.

Yes, when the sub-base is properly compacted and the surface is graded with a slight slope, typically 1 percent, water runs off rather than pooling. A court built on an unstable or poorly drained base will settle unevenly over time. Every installation starts with a drainage evaluation to address these conditions before the base goes in.

Cracking almost always traces back to sub-base failure, soil that wasn’t compacted properly, poor drainage causing freeze-thaw movement, or tree roots shifting the ground beneath the slab. Surface-level cracks from UV exposure are cosmetic and repairable, but structural cracks that run through the base need assessment before resurfacing. Court repair and resurfacing can address both types.